3000VT Makita Saw - Parts

This is an OEM part sourced directly from the manufacturer. The needle bearing is found in Makita reciprocating saws. This part is made of metal, and is placed in the gear housing to allow the gear shaft to spin freely. You will require a screwdriver when replacing this item. This product is available as an individual replacement part.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

This compression spring is a genuine OEM replacement component designed to maintain proper tension and support smooth internal operation across a variety of power tools. Made from durable spring steel, it helps ensure consistent movement within mechanisms such as levers, guides, or trigger systems, contributing to stable performance and r...Read moreeliable tool function. Replacing a worn or weakened spring helps restore proper pressure, improve responsiveness, and maintain overall efficiency during regular use.

This is a Genuine OEM replacement part used on some Makita Power Tools. This is a Metal Spring and it is Sold Individually. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.

This is an Genuine OEM replacement Compression Spring used on Makita Reciprocating Saws. It is sold individually. This is the Spring that Pushes Shoulder Pin 5 within the Driving Guide Sleeve. Please refer to diagram when ordering parts.

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually re...Read morequire replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

This is an authentic Makita manufactured for use with electric power tools. The special strain relief is commonly used to secure the power cord wires to the switch block to prevent the wires from being pulled out of the switch. This strain relief is available as an individual replacement part, please see model diagram for associative parts.

It is an authentic OEM sourced replacement part designed for use with Makita power tools. This is a standard hardware which has multiple applications depending on your unit, please refer to diagrams for proper application. It is made from strong, durable metal and it is sold individually.

This push plate is supplied directly from the original equipment manufacturer. The Makita part is constructed of durable metal, and is compatible with several reciprocating saw devices. This item is fitted between the compression spring and sleeve, and assists in the blade clamp assembly. A screwdriver is needed in making the repair. This part is sold individually.

This is an authentic OEM sourced replacement part designed for use with Makita reciprocating saws. This part helps securing the sleeve inside the tool. This part is made out of plastic and it is sold individually.