3000VT Makita Saw - Parts

This authentic Makita replacement part is designed for use with reciprocating saws. This pin fits in the guide sleeve and it helps to secure it in place. This part is made out of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This replacement tapping screw is an authentic item that is supplied by the original manufacturer for use with Makita power tools. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this part. This high-quality phillips pan-head screw is made of durable metal and it is sold individually.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This is a genuine replacement part which is supplied directly from the original equipment manufacturer. The plastic insulation washer sits between the ball bearing and the armature assembly. This part is used on nibblers, shears, planers, jig saws, masonry saws and circular saws to disperse heat as well as insulate the surrounding components. This part is sold individually.

This is an authentic manufacturer approved replacement part designed for use with Makita reciprocating saws. This part fits in the side of guide sleeve. It is made out of metal and it is sold individually. To complete this repair you would need pliers.

This is a genuine OEM replacement part used on Makita reciprocating saws. It is made out of metal and it is sold individually. It is an important part of keyless blade clamp allowing for quick blade change. To replace it you may need a screwdriver and pliers.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This authentic replacement ball bearing which is supplied by the original manufacturer, it is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, they experience constant wear from pressure, heat, vibration, and friction eventually requiring replacement to maintain peak per...Read moreformance. It is generally used as one of the armature bearings, for correct application make sure to check appropriate diagrams of your model. This part is made of high-quality metal and it is sold individually.

This item has been sourced from the original manufacturer to be used with reciprocating saws from Makita. The metal needle bearing attaches to the gear assembly. The bearing is used to reduce friction between the gear shaft and the bracket on the slide. This item is available as an individual replacement part.