25331430102 Kenmore Refrigerator - Instructions

Snap out the old, Snap in the new. With a "Special Needs" child at home, doors are slammed. Inside retainer bars take abnormal abuse .. Parts Select, "Saves the day" and I have a HAPPY Landlord.

I found the part on PartSelect.com, ordered it, received it, and installed it in less than 3 days. Thank you PartSelect.com! I wish everything was this easy.

First I had to remove the popsicle sticks and glue that had been semi-repairing the bracket for 1+ years. Then I popped it back together. Too easy.

Slip the endcap off the door--- no tools required for that. Use flat end of screwdriver to loosen the bracket holding the door bar into the endcap. The bar slides right out, is easily replaced, and the endcap slips right back on to the door.

The retainer bar was missing from a refrigerator in our rental property. A tenant had broken it and thrown it out. I found the model # on the appliance and looked up the parts diagram on the PartsSelect website and found what I needed. I placed the order one day and had the parts 2 days later! Unpacking was the hardest part. The parts jus ... Read more t snapped together to make up the complete retainer unit. Then I just fit the unit onto the formed clips on the door shelf. I'd cosider this a " simple" job.

Popped off the old and slipped on the new. No tools - in less than 5 minutes.

Need to repair refrigerator for new renters. Ordered parts and received them two days later. Installed retainer bar with end caps into refrigerator door same day parts received.

Not much placed the 2 ends on the straight bar & put it in place on the refridgerator door dom russo

Remove and replace.

I removed the door actuated light switch with my index finger and thumb on my right hand. I then removed the two wires from the switch. I noticed that the new switch had different look to it,I think Frigidaire must have had a problem with the original design of the switch. Reassembly was just replacing the two wires and putting the new sw ... Read more itch in place, and no more door closing problem.

none

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

measured lenght of parts looked at parts available and matched the size and use together slip broken part off door replaced with newpart. reinstall retainer to to door no tools needed.

I snapped out the broken piece of the old Door Shelf Retainer Bar End Cap, snapped in the new one and reinstalled the door rack in my refrigerator.

These were easy pop in pieces so no tools were needed. Very easy and quick. What I liked best about PartSelect.com was the pictures and labeling used in order to select the correct part. That was my biggest concern. It only took me about 15 minutes to find and buy the parts I needed.