2325ERS Jenn-Air Cooktop - Instructions

Simply pull off the old ones and replace with the new ones. Problem was finding the correct knobs with the double "s" shaft fitting.The item number indicated by the model number was incorrect. I saw a kit with four knobs on your web site and ordered the kit and not the recommended item. Turned out to be the right move and the knobs fir just fine.

Placed new burner knobs onto cooktop. easy

I just lined up the parts and put them in the burner. After a year of spending money and many hours, trying to get wrong parts to work and trying to get something that fit and didn't leave gaps, I got parts that really fit and work and were exactly like the parts they replaced! The woman I spoke to was very helpful and helped me to order the right drip pan! I got the parts very quickly and was very pleased with the woman that helped me with my order. My Jenn-Aire works and finally heats perfectly now and I am very pleased! Thank you everyone!

Turned off the circuit breaker! Removed the four Phillips screws below the trim, parallel to and above the oven door; removed the trim, then the nut holding the switch (below the knob, removed). Replaced the terminal lugs one at at time from broken switch to new switch. Replaced new switch, nut, trim and screws. Pulled all four burners and replaced drip pans; replaced burners and replaced old control knobs with new knobs. A pleasure working with American made appliances designed to be repaired and not just thrown away! ( P.S.: Parts were delivered to but not for Derickson Lumber Co.) Dick Ford

This down draft filter was just what I was looking for. The big box stores (Home Depot and Lowe's) do not carry this size filter. Thanks,

It was simple! The range looks so much better!

Great company....Fast delivery.

follow the EASY to read and understand instructions.replaced all 4 controls in about 35 min.

removed old motor from cooktop & motor housing & replaced w/ new motor & parts to install same. parts needed where screws & isolators (3).All went ok

Old filter allowed too much air flow causing exhaust fan to go off....installed new filter in exhaust chamber...release clip on old filter and install new filter (at an angle) in the exhaust box....clamp down clip on edge of filter and job is complete

Turn off power to cooktop. Lift the broken infinite switch knob off the switch console. Use pliers to remove the hex nut that is under the knob. Then remove the grill over the exhaust vent to expose the two screws that hold the switch console in place. Using a philips head screwdriver, unscrew the two screws and lift the console up as far as the wiring will let you. Push the two little clips on either side of the electrical component you want to replace, to release it from its harness. Pay attention to the wires of the broken switch and pull one off at a time and attach to the new part. I used a knife to pry the wires off the electrical pins. Once all wires are reattached, clip the component into the harness and attach the hex nut back onto the protruding d-stem. Put all back together and test the switch before turning power back on. If ok, turn power on and test again.

I replaced the rims and bowls in less than 5 minutes, and they improved the looks of my cook top so much that I am no longer considering purchasing a new cook top!!! My cook top was purchased in 1979, and other than the rims and bowls is in excellent shape, and the new parts made my cook top look as good as new. I am very happy with my parts, and have already recommended PartSelect to my children.

PS made finding an old bowl/ring adapter easy.