2320ERS Jenn-Air Cooktop - Instructions

Took the front panel off by removing 4 screws. Then remove the switch by loosing the nut hold it. Then replace the wire on the new the way they were on the old switch. Put the panel back on.

I just lifted out old filter, and put in new one.

This was a no-brainer: old filter out, new filter in. In addition to replacing an old, greasy filter, I found that the exhaust fan now draws cooking fumes much more efficiently. So why did I wait the 6 years since we moved into this house to do this???

couldn't find replacement in our town, which is quite
small and no Maytag dealers. So, I ordered on line two drip bowls and saved one"just in case"

Mission accomplished. Thanks allot.

Removed old filter, dropped in the new one.
(This really was not a "repair")

old filter fell into from removing and cleaning,
removed cover pulled out filter ,replaced it with new one.

Unplugged the burner units and replaced the drip pans. Five seconds time per burner.

Followed the directions. Piece of cake!!

Very simple for me!!! Open the box, uncover the new grill and lay it in its place.


Thank you so much!

I originally ordered the knobs that appeared to be an exact match for the ones on the stove top (Part # PS1515077). However those knobs are designed to fit on D post stems. I finally ordered PS48861 which are designed to fit double flat post stems which is what I have on my stove top. New parts fit perfectly. Remove old knobs put new ones on. Total repair time less than one minute. Part Select was great about getting the original parts and replacement to me quickly.

Replacing the switch was very easy. First I unplugged the range to be sure there would be no electrical power to the switch. Then I removed four screws to remove the switch cover plate (located above the oven door). I disconnected the wires from the pin connectors on the broken switch, then removed the switch by removing one hex nut. The new switch was installed by reversing the removal procedure. Took about 15 minutes total time.

I installed a new infinite switch, which created a new problem. The large burner switch turned the small burner on. I replaced the large burner switch an that stopped that problem. But now the small burner still only comes on to high temp. Need help in determining how to correct that problem.I had already replaced the small burner switch before I replaced the large burner switch and I still have the small burner only coming onn to high heat.

shut circuit breaker, remove two screws, lift knob panel, move wires to new switch, remove and replace switch, clean surface

As stated on order.

Thanks, have been looking for a replacement for this dinosaur filter forever. It is great!