1984 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
changed defrost timer
-
Gerry from Apache Jct, AZ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
followed the video very esay
Was this helpful?
Thank you for voting!
Fan Motor Malfunction
-
Donald from Waynesburg, PA
- Easy
- 15 - 30 mins
-
Nutdriver
Followed the instruction video. Removed the old one. Attached the fan blade, ground wire and connected power plug. Reinstalled with 2 screws. Works great.
Was this helpful?
Thank you for voting!
Failure of temperature control
-
Barbara from Marcellus, NY
- Easy
- 15 - 30 mins
-
Screw drivers
Unplugged refrigerator. Removed control knob and cover. Unwired control and removed same. Removed plastic tube from old capillary tube and placed on new unit. Installed and wired in new unit, making sure new unit was in the "off" position. Plugged in refrigerator, turned control knob to the first numerical setting, and was rewarded with t
... Read more
he startup of the refrigerator compressor. Voila!
Read less
Was this helpful?
Thank you for voting!
fridge not blowing cold
-
wayne from marietta, GA
- Easy
- 15 - 30 mins
-
Nutdriver
bottom left cornerof fridge defrost timer replaced two bolts and a wire
Was this helpful?
Thank you for voting!
the freezer coils were not defrosting so they would ice up and cut off the cold air into the refrigerator side
-
mark from murrieta, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
there were three possible problems the timer, the thermostat, or the heating element.i replaced the timer first as that is the problem 65% of the time and that did not fix the problem, i replaced the thermostat and that did fix the problem. after watching the video on line from parts select i took the back off of the freezer from the insi
... Read more
de, defrosted the coils with a hair blower and then swapped out the thermostat which pops right off and i spliced the old connectors to the new thermostat. the heat shrink tubing that came with the part was a little to big so i put a smaller peice on each side for water proofing. that is what the cigarette lighter is for to supply heat to the heat shrink tubing.now that i have fixed that problem i may tackle the ice maker next
Read less
Was this helpful?
Thank you for voting!
It would freeze up or not cool at all, depended where the clock stopped.
-
Roger from Owatonna, MN
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed the lower trim panel from front of fridg. and loosened two screws enough to turn it about 1/4 inch so the screw heads were in the larger holes. Pulled it out disconnected the wire connector and transfered the heat shield and screws to the new clock, connected the wire connector and aligned the screws. tightened them and job done.
... Read more
Has worked like new sense. Thanks Roger
Read less
Was this helpful?
Thank you for voting!
Refrig would not defrost
-
Robert from Jacksonville, FL
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious pro
... Read more
blems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.
Read less
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
-
VINCENT from DEPTFORD, NJ
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
-
Robert from Chicago, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!
Refrigerator was not cooling
-
Scott from Norman, OK
- Really Easy
- Less than 15 mins
-
Nutdriver
Remove 4 screws that hold up overhead controls, this is also the part that holds the light. Unplug the timer and replace. Super simple and runs great now. After you plug it in it may take a few minutes to kick on the compressor but it will. Also I was pleased it was a factory Frigidare part. Price was right.
Was this helpful?
Thank you for voting!
freezer was freezing and no refrigerator
-
Michael E from Uniontown, PA
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Followed instruction vedeo from partselect. THANKS!!!!!
Was this helpful?
Thank you for voting!
frig side not cool/freezer coils not defrosting
-
daryl from n.las vegas, NV
- Really Easy
- Less than 15 mins
unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
-
PAUL from WEIRTON, WV
- Really Easy
- Less than 15 mins
-
Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
Freezer worked, Frig would not cool.
-
Dean from Sunset, SC
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Unplugged the frig. Removed temp control module from frig, 1 screw with nut driver. Activated defrost timer by rotating adjustment until 2 clicks are heard. Removed two timer mounting screws, unpluged timer, plugged in the new timer, mounted it to the control module with 2 mounting screws. Replaced control module with the 1 mounting sc
... Read more
rew. Closed door and plugged it up.
Read less
Was this helpful?
Thank you for voting!
at first auto defrost would not work so I had to take the frezer panel apart and defrost it with a hair dryer every ten days
-
thomas from Chepachet, RI
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!
Was this helpful?
Thank you for voting!