1927 - Parts

Door switch turns the light off when you close the door.

This condenser fan motor operates in a clockwise fashion and carries carries 2W and 115V. It comes with screws, a mounting nut for the blade and a cushion. This part provides forced-air cooling for the condenser coil.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This 48 cube ice cube tray is eleven inches long. It is all white in color and it is made entirely of plastic.

The water inlet valve is a solenoid-operated switch located at the bottom of the refrigerator. When it is energized by electrical power, water is released from the supply line through the water valve and into the compact icemaker mold. ***Please NOTE: This part has been redesigned and may appear different than the original. It has a new...Read more quick connection. To install: cut the retaining nut off the existing water line and gently push into new valve. To remove: depress the ring that the tube slides into.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This evaporator fan motor assembly is just over three inches long. It is made of both metal and plastic, and is made up of black, white, and metalllic pieces.

Sold individually.

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

This compression nut is used with the plastic water line of the icemaker assembly.

This kickplate clip is an inch long and is made of metal. Two are needed per refrigerator.

1/4" Plastic tubing, 8 1/2 feet long.