12AV Craftsman Lawn Mower - Parts

This is an authentic manufacturer-sourced replacement part which is specially made for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. It is a standard hardware which helps to secure the piston. Please make sure to refer to the appropriate diagrams for your model for the correct location...Read more and application of this pin. Keep in mind this high-quality part is made of durable metal and is sold individually. Pliers will be needed to secure or remove it.

This is a genuine Briggs & Stratton replacement part. The screw is commonly found in small engines. This part is made of metal, and is generally used to hold the rocker cover in place. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton and Toro. The o-ring seal attaches to the dipstick. When replacing this part a socket set might be required during the installation process. I...Read moret is made out of rubber and will need to be replaced if it breaks. This part is available as an individual replacement.

This is an original replacement part sourced directly from the manufacturer. The control lever is commonly found in engines, generators, and pressure washers from Briggs & Stratton, and in lawn tractors from Toro. This part is made of metal, and is used to adjust the control wire that connects to the engine. You may require a wrench or...Read more screwdriver when replacing this product. This item is sold as an individual replacement part.

This is an original part from Briggs and Stratton for use with lawn and garden equipment engines. The carburetor float controls fuel flow into the carburetor bowl by adjusting the needle valve. The most common reason for replacing the float is when the engine is leaking gas. This part is sold individually. Here is a list of tools that are...Read more needed to replace the carburetor a 1/4 inch socket or nut driver, 3/8th inch socket or nut driver, 7/16th inch socket, 5/16th inch wrench, and a Phillips-head screwdriver.

This is a genuine Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with small engines. The dipstick fits into the top of the crankcase assembly. This item is used to seal the oil fill spout and also can be used to provide an indication of the oil level. The part does not require tools to install and it is sold as an individual replacement part.