11977 Kenmore - Parts

This single water filter is designed for use in side-by-side refrigerators, positioned in the front top-right section for easy access. It utilizes a carbon-based filtration system to reduce a wide range of contaminants, including cysts, turbidity, lead, mercury, and herbicides, ensuring cleaner water and ice from the dispenser. Measuring ...Read more6 x 3 x 7 inches and constructed from white plastic, the filter is engineered for performance and ease of replacement. Common symptoms indicating the need for replacement include reduced ice production, dispensing issues, leakage, and unusual noise. The filter should be replaced every six months or after 200 gallons of use, as indicated by the red light on the freezer door dispenser. Installation requires no tools: press the release button to remove the old filter, insert and lock the new one, then run water

This genuine PureSource Ultra water filter will fit most Frigidaire french door and side by side refrigerators. You will find this filter located in the back, top right of the appliance. It is white in color and the filter has a polypropylene plastic housing and extruded carbon block filter media. Certified by NSF/ANSI to reduce contamina...Read morents that may be in your household water supply by 99.8 percent. The operating temperature for this filter is 33-100 degrees Fahrenheit, the flow rate is 0.5 GPM, the working pressure is 30-100 PSI, and it has a micron rating of 1. This filter should be replaced every six months or when the indicator lights up red. Installation is quick and easy. Push on the end face of the older filter to allow it to release. Remove and discard the old filter. Slide the new filter into the housing and press it down until it locks into place. Be sure to run water through the dispenser for about three minutes to prime the filter before use. Discard this water or use it to water plants. Do not forget to reset the indicator by pressing it down for 3-10 seconds. Review the use and care guide before you install for more detailed instructions.

This flat style gas oven igniter has an amperage range between 3.2 to 3.6. This part comes with two ceramic wire nuts.

Sold individually.

Sold individually.

This hinge is located on left side of the oven door.

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

This knob allows you to control the temperature of the surface burner. Sold individually.