110C8 Kenmore - Parts

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This part is located in the control panel. It senses the resistance change and opens and closes a relay sending power to the dryer heater.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This part seals between the blower housing and the blower housing cover.

With this kit it allows you to open the door from the left or right side.

200F

This part gets the motor up to speed quickly before transferring power to the run capacitor.

12-14 X 5/8. Sold individually. Your appliance will most likely require 4.

This kit does NOT come with screws or bolts. Must use originals.

This parts covers the bulb inside the drum.