1106117821 Kenmore Dryer - Instructions

All Instructions for the 1106117821
106 - 120 of 200

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Door Gasket Broke into pieces
1 of 3 people found this instruction helpful.
  • Cheryl from Phoenix, AZ
  • Really Easy
  • Less than 15 mins
It was so easy! I simply fit the gasket into the groove where the old one had been. Didn't even need any tools.
Was this helpful?
Thank you for voting!
washer would fill with water but not start
5 of 15 people found this instruction helpful.
  • Edward from Nanuet, NY
  • A Bit Difficult
  • 15 - 30 mins
  • Nutdriver, Screw drivers
took part top of washer saw switch replaced it not to difficult it is always easier when you have new one to look at
Was this helpful?
Thank you for voting!
burned oven bulb
3 of 9 people found this instruction helpful.
  • Ivanka from Atlantra, GA
  • Really Easy
  • 30 - 60 mins
  • Pliers, Screw drivers
The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new ligh t bulb in was not the problem.
Was this helpful?
Thank you for voting!
Washing machine over 20 years old but still runs strong door switch actuator spring broke original spring was not availible.
0 of 1 people found this instruction helpful.
  • Larry from Elmhurst, IL
  • Easy
  • 30 - 60 mins
  • Screw drivers
drilled a 7/16 diameter hole directly in the center of the two mounting holes filed it square big enough so as the spring tip fits thru now the door closes on the spring which actuates the switch looks and works perfect.
Was this helpful?
Thank you for voting!
Dryer would not activate
2 of 7 people found this instruction helpful.
  • Andris from Sands Point, NY
  • Easy
  • 15 - 30 mins
  • Pliers, Screw drivers, Socket set
>removed 2 screws connecting the vent filter to the top lid of the unit (just in front of removable filter).
>Losing two screws at the back of the machine, just below control panel to allow free movement of the top lid on its hinges.
>Raise top lid & supported open.
>Now have free access to door switch (inside , front right fastened to front panel)
>removed the old switch
>fasten new switch (required new wire connector which was supplied with package) to existing wiring and replaced.
>Works perfectly!
Was this helpful?
Thank you for voting!
The dryer door kept popping open while in use.
0 of 1 people found this instruction helpful.
  • Joseph from Margate, FL
  • Easy
  • 15 - 30 mins
I googled the problem, then came across a site where somebody had experienced the same problem, and they changed the door catches to resolve it. I did a search for Whirlpool parts and found "partselect.com". I followed the instructions on the website and located the parts very easily and also discovered that there was a video on how to ma ke this repair. We were tolerating this problem for quite some time and now the problem is resolved, thank you...
Was this helpful?
Thank you for voting!
Dryer would not come on
0 of 1 people found this instruction helpful.
  • Steven from Bassett, VA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
Replaced the cap over the door switch so when the door closed the switch was engaged
Was this helpful?
Thank you for voting!
Dryer won't start!
0 of 1 people found this instruction helpful.
  • Richard from Paradis, LA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Googled dryer won't start! From information on the Parts Select website, I determined it was possibly the dryer door switch. Checked the dryer to confirm status of door switch and found it broken! Ordered part and received it within 2 days (actually ordered on a Sunday and it shipped on Monday with receipt on Wednesday. Unpluged the drye r. Used information from Parts select website to remove two screws from vent filter, used screwdriver to pop the top of dryer at each front corner, removed two long screws from the old switch and replaced the broken actuator on the switch with the new actuator received from Parts Select. Note: It was easier to remove old switch with the wires removed from terminals (just pull off), replacing the wires after securing the switch and actuator back in place. Piece of cake, wife happy, received her king of the roost reward :>)) This is also a good time to clean the lint filter area and the hoses to prevent one of those 16,000 annual dryer fires!!!
Was this helpful?
Thank you for voting!
My dryer door would not stay shut.
0 of 1 people found this instruction helpful.
  • Michelle from Colby, KS
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I removed the old door catch by using a screwdriver to pry it out, then I popped the new door catch in its place and it snapped right in. It took less than 5 minutes to do the whole job.
Was this helpful?
Thank you for voting!
the door switch broke, and I had to pop the lid unscrew the switch and use a clothespin to depress the switch acuator button....not pretty.
0 of 1 people found this instruction helpful.
  • Greg from Phoenixville, PA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
same as I described above. However i was amazed when the part showed up the very next day...I was expecting maybe 3 or so days later. I wiil absolutely use PartSelect in the future.
Was this helpful?
Thank you for voting!
Door would not latch closed when shut
0 of 1 people found this instruction helpful.
  • Carl from Port Arthur, TX
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Reviewed the video showing how to remove the bad-order part and install the new part. No problem. Installing the new part was exactly what was shown in the video on the web page.
Was this helpful?
Thank you for voting!
broken door catch. door wont close properly
0 of 1 people found this instruction helpful.
  • juan from los angeles, CA
  • Easy
  • Less than 15 mins
  • Screw drivers
i watched the video from Part Select. did exactly as seen and presto it was easily done. never could've done it without Part Select.
Was this helpful?
Thank you for voting!
Part of the dryer door latch fell out and was lost. Needed to replace it.
0 of 1 people found this instruction helpful.
  • William from Alpharetta, GA
  • Really Easy
  • Less than 15 mins
When I ordered the part, I viewed the installation video. That was a key step for me. It told me how to identify the correct part (there are multiple latch pieces in the repair kit, and one of them matches the type of door for the dryer), and how to disassemble the door to get the part installed. When the part came and I installed it, it turned out that I could snap the part in by hand, with no tools. It took about 5 seconds to try it, and it worked.
Was this helpful?
Thank you for voting!
Dryer would not start
0 of 1 people found this instruction helpful.
  • Tim from Pepperell, MA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
The dryer just stopped after a new load of clothes was put in. It appeared to be a power problem as there were not warnings, it just stopped. After checking the power, I suspected it was an electrical interlock problem. After nosing around, I traced the power to the dryer door interlock. Sure enough the switch was fine, but the mechan ical lever was worn away. After Googling around for a replacement I found PartSelect.Com. Found the part, ordered it, and I am back in business. My wife is not happy though, as she wanted a new dryer:)
Was this helpful?
Thank you for voting!
light bulb went out in my oven
2 of 7 people found this instruction helpful.
  • Janet from Ada, MI
  • Really Easy
  • Less than 15 mins
My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.
Was this helpful?
Thank you for voting!
All Instructions for the 1106117821
106 - 120 of 200