11034 Kenmore Dryer - Parts

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and ...Read moreis made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

This silicone carbide igniter with ceramic holder kit includes the 3" flat igniter, bracket, 4" wire leads, and the plug. It can replace both round and flat igniters. This kit is used for many gas clothes dryers.

This gas dryer conversion kit allows a dryer that is set up for natural gas to be converted for use with liquid propane (LP) gas. The kit includes the key components needed for the conversion, including burner orifices, a regulator vent cap, and a conversion decal. You may need this kit when installing a dryer in a location that uses LP g...Read moreas instead of natural gas. Using the correct conversion kit helps ensure proper gas flow, reliable heating performance, and safe dryer operation after the conversion is completed.

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This screw is sold individually.

This gas valve kit comes with the wiring harness.

Includes hood.