This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.
This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the spl...
This part changes the transmission from agitation to spin mode. This actuator is for washers.
Actuator shifts the splutch and monitors the position of the splutch.
This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, you...
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Lisa
June 2, 2023
Washer suddenly stopped spinning filling etc. I can set the cycle but when I push start it just sits there. I'm thinking the computer board?
For model number 11026002010
Hi Lisa, thank you for reaching out. Based on the description that you have provided, we would recommend checking the lid latch assembly, part number PS3497627, to fix this issue. We hope this solves your problem!
when it spins it gets out of balance and shuts off.
For model number 11026002010
Hello Charly, thank you for the question. We would recommend checking the suspension rod kit, part number PS11703291, to fix the issue. We hope this helps!
Makes a loud squeaking sound. Like something is rubbing. This happens during the wash cycle. Thanks.
For model number 11026002010
Hi Charly, thank you for getting in touch. Based on the description that you have provided, we would recommend replacing the drive hub kit, part number PS2581262, to fix the issue. We hope this sorts out your problem!
Washer still making a loud grinding sound in wash cycle. Plus it isn’t spinning out close completely they are still very wet. I have replaced washing machine drum mounting hub, top load washer drive belt, washing machine drive pulley clutch, and washing machine shift actuator. And it’s still sounds bad. Help !!!! Thanks.
For model number 11026002010
Hi Charly, thank you for reaching out. Based on the description, the issue is with the drain pump, part number PS11751719. We would recommend replacing the drain pump to fix the issue. Glad to be of help!
A detailed Service Technician Service Manual is hidden inside the machine on the front panel. It is hidden by the bleach dispenser input. It gives a list of fault codes and instructions for calibration after repair, resetting fault codes, and a manual test mode for stepping the machine through each mode on command. The Tachometer failed which would not let the machine come up to maximum spin speed. The tachometer is part of the solenoid actuator that shifts the transmission. It is not specifically called out in the manual. Any failure causes the lid lock light to blink which gives the appearance of a lid lock failure
The instructions that came with the part were worthless. Essentially, unplug, put in new part, plug it back in. I spent a considerable amount of time on the internet and finally found a video showing how to open the top. Unlike other models, it is held down by clamps in the back rather than clips in the front. Once finding this information the installation was simple. Remove the clamps and the back of the console, slide the top forward and lift, remove and replace the lock and reassemble. You don't even have to remove the hoses.