1028B Roper Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Lower igniter wouldn't light oven didn't heat up
-
Leonard from Hamilton, NJ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
Ordered the part from you it came the next day didn't need to pay for upgraded shipping, nice. Followed the easy instructions on your site. It had all the right hardware it literally clipped on the wires and bingo worked like a champion. I've done this on many ovens it sure beats calling an appliance repairman and getting ripped off for a
... Read more
15 minute job. Thanks.
Read less
Was this helpful?
Thank you for voting!
gas oven wouldn't ignite
-
James from Alexandria, MN
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
Removed the floor of the oven. Removed the flame difuser covering the burner. Igniter was in plain sight. Turned on the oven and saw that the element in the igniter did not glow. Removed the igniter. Found a replacement on this site. Ordered the replacement part, which I received 3 or 4 days later. Installed the new igniter. Turne
... Read more
d on the oven. Saw the igniter element turn bright red. Replaced the difuser and the oven floor. Turned on the oven and bake 2 loaves of sour dough bread.
Read less
Was this helpful?
Thank you for voting!
could not control temp on burner
-
Ernie from Cameron, MO
- Really Easy
- 15 - 30 mins
-
Pliers
Took appro 8 screws out of back panel, 2 screws holding switch, and pulled out switch, unhooked wires and reinstalled wires on new switch. Had to snap off stem with needle nose pliers which is simple and put everything back in place in reverse order!
Was this helpful?
Thank you for voting!
the dial would not work unless the special screws, which are extra short, are utilized.
-
Bruce E from Oxford, MS
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
since I only had one of two screws, i installed with just the one. it would not work at all using a slightly longer screw, which is very odd.
Was this helpful?
Thank you for voting!