020454-00 Briggs and Stratton Pressure Washer - Parts

This is an authentic OEM part for use with Briggs and Stratton Pressure Washers. The chemical injection connector connects the chemical injector to the pump. This part is sold individually. The most common reasons for replacing the injector kit are when water is getting into the soap dispenser, the chemical injector nozzle is leaking, or ...Read morethe pressure washer soap injector is not working at all. The tools that you will need to replace the chemical injector are pinch-off pliers, 13mm wrench, and a flathead screwdriver.

It is a high-quality item that is supplied by the original equipment for use with Briggs and Stratton, Troy-Bilt and Snapper pressure washers. The kit includes a fitting that allows a user to connect the hose that supplies the chemical cleaning solution. Unfortunately, over time components on your equipment may wear out or get damaged eve...Read morentually requiring a replacement. Make sure to check the appropriate diagrams and the owners manual of your model for the correct installation of these parts. The kit includes one durable brass fittings, a metal ball, a spring and a rubber seal. To replace it, you will need a wrench set to remove the old fitting and secure the new one.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The hardware is used to attach the motor to the frame assembly. The kit includes rubber isolators that absorb engine vibration. This kit is sold complete with all the parts that are in the photo.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This is a genuine Briggs and Stratton and Troy-Bilt part for use with Pressure Washers. The unloader valve kit includes the parts needed to replace the unloader valve, which opens to relieve water pressure and recirculate water through the pump when the spray wand isn't in use and the pressure washer is running. The most common reason for...Read more replacing the unloader valve kit is if it is damaged. The tools that you will need to replace the unloader valve is a screwdriver, pliers and a Wrench Set.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.