020333-3 Briggs and Stratton Pressure Washer - Parts

This authentic manufacturer-supplied part is specially designed for use with Briggs and Stratton, Troy-Bilt and Snapper pressure washers. It is a special hardware that helps to secure components. This is an identical replacement for a missing or a damaged retainer clip that was installed on a new unit. Note, it is made of durable plastic ...Read moreand is sold in a pack of four. Make sure to refer to the owner's manual and the appropriate diagrams for your model to ensure the proper replacement procedure.

This is a genuine replacement part sourced directly from the manufacturer. The valve fuel kit is commonly found in Craftsman pressure washers and generators. This part includes the valve made of high-quality plastic, and a rubber cap. It is used to carry fuel from the tank into the engine. You may require a screwdriver or Allen wrench when replacing this item.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This is an authentic OEM part from Briggs and Stratton, Troy-Bilt, and Snapper for use with Pressure Washers. The Briggs & Stratton Pressure Washer Pump Saver prevents harmful buildup of hard-water mineral deposits in the pump, maintains pump seals and pistons and promotes longer pump life. It contains anti-freeze to protect the pump from...Read more freezing and provides safe winter storage. This part is sold individually. No mixing, stirring or shaking is required. Just attach the pump saver to the pump and dispense.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replacing the spray wand are when it is worn-out or is leaking. This part is sold individually. The tool that you will need to replace the wand is a 5/8 inch wrench. Shut the pressure washer off before installing the wand.

Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.