KitchenAid Washer Hardware

KitchenAid Washer Agitator Bolt

★★★★★

★★★★★

5 Reviews

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

KitchenAid Washer

★★★★★

★★★★★

1 Review

This part goes on the agitator retaining bolt.

KitchenAid Washer Suspension Spring Retainer

★★★★★

★★★★★

2 Reviews

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

KitchenAid Washer Hose Clamp This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

KitchenAid Washer Knob Springclip

★★★★★

★★★★★

1 Review

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

KitchenAid Washer Dryer Screw This screw is sold individually.

KitchenAid Washer Hose Clamp This hose clamp is sold individually.

KitchenAid Washer Spanner Nut If your washer is noisy or shaking, the spanner nut might need replacing. This part locks the inner tub to the drive block so it spins smoothly during cycles. It has a right-hand thread and is easy to install with basic tools—just make sure the washer is unplugged and water is turned off before you start. A simple fix for a quieter, more efficient wash.

KitchenAid Washer Bellow Clamp

★★★★★

★★★★★

3 Reviews

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow into place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

KitchenAid Washer Pump Retainer Sold Individually.