Kenmore Washer Motors

Washing Machine Drain Pump

★★★★★

★★★★★

66 Reviews

The drain pump and motor assembly may also be known as the washer drain pump and is a part for your washer. The drain pump helps expel water from the washing machine. The drain pump is activated after the spin cycle speed is maintained for a specific period of time. To make this installation you will need a Phillips screwdriver, a small flat-blade screwdriver, a pair of needle-nose pliers, and a pair of slip-joint pliers. Note that the pump casing is not included. This medium-difficulty repair may vary, but can generally be started by disconnecting power, then removing the top of the washer by taking out the four back screws and two small brackets. Then, remove the front panel by taking out the two screws and eight tabs that should be taken from the top. Moving down the front of the washer, remove the door, latch, tub gasket, and drain cover. Disconnect the drain hoses and clip from under the drain assembly, and install new assembly from there. Reassemble parts in direct reverse order -- taking photos during disassembly and keeping parts clearly organized can help here. Despite the number of steps, you will only need a standard Phillips screwdriver to complete this repair.

Direct Drive Motor Coupling

★★★★★

★★★★★

61 Reviews

This coupling kit is located between the motor and the transmission on direct drive washers with no belt. This is the newer version and is made with new metal sleeves for added strength.

Drain Pump Kit

★★★★★

★★★★★

27 Reviews

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. This part is used on front load models.

2-Speed Drive Motor - 60Hz 120V

★★★★★

★★★★★

1 Review

The drum is driven directly by the motor, replacing the usual belt or gearbox-driven system which increases efficiency and decreases noise. NOTE: The cardboard is not included with this part.

Washer Motor Rotor The motor rotor connects to the spin basket shaft and rotates the spin basket

Remote Style Pump with Motor

★★★★★

★★★★★

4 Reviews

Use this with either a top load or front load washer. This pump has an horizontal mount.

Rotor Assembly

★★★★★

★★★★★

1 Review

This rotor assembly is a manufacturer-approved replacement part for your washing machine. The rotor is an important part to rotate the tub during the wash cycle. It can need replacing if the magnets or splines become damaged. Unplug the washer before beginning this repair. To complete this repair, you will need a Phillips screwdriver, a 17mm socket wrench, and thread-locking fluid.

Rotor Assembly

★★★★★

★★★★★

1 Review

ROTOR ASSEMBLY

Washer Drive Motor The drive motor spins the spin basket and drives the agitator or spin basket in the agitation or tumbling mode.