Kenmore Washer Hardware

Popular Kenmore Washer Hardware

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".
This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".
What this part fixes:
  • Leaking
  • Marks left on clothes
  • Spinning Issues
$12.05
In Stock
What this part fixes:
  • Spinning Issues
  • Will not agitate
What this part fixes:
  • Leaking
This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.
This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.
What this part fixes:
  • Door won’t close
  • Noisy
This part goes on the agitator retaining bolt.
This part goes on the agitator retaining bolt.
What this part fixes:
  • Leaking
  • Will not agitate
Original Equipment Manufacturer

MAKE THIS REPAIR A GUARANTEED WIN

OVER 2 MILLION PARTS TO ENSURE VICTORY

$19.28
In Stock
This part is used for the shaft on rear of the tub. Sold individually.
This part is used for the shaft on rear of the tub. Sold individually.
$11.61
In Stock
Sold individually.
Sold individually.
What this part fixes:
  • Will not agitate
What this part fixes:
  • Leaking
$39.55
In Stock
What this part fixes:
  • Leaking
This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.
This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.
What this part fixes:
  • Shaking and Moving