Workbench Parts

This is a genuine Black and Decker replacement part. It is sold Individually. The part will hold the leg on the Workmate in the down position and lock it in place. By releasing this part the leg can be raised back into the up position.

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on. It attaches the 242415-02 Leg.

This is a genuine Black and Decker replacement part, it is sold individually. The Snap-In Knob is installed in the 242302-00 Crank Handle, on the list of Wormates shown below. Its purpose is to rotate the crank vise to open or close the vise jaws.

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on.

This is an Authentic OEM sourced replacement part designed for use with Black and Decker Workmate. This item helps to secure the Vise Screw. This Pivot Nut is made out of Plastic and it is Sold Individually. To replace it you would need a Wrench.

This item has been sourced from the original manufacturer to be used with work benches from Black and Decker. The slide block attaches to the bottom of the table and is used to allow the table to move across the rails. This item is sold as an individual replacement part.