WM225 (Type 5) Black and Decker Workbench - Overview

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on. It attaches the 242415-02 Leg.

This is a genuine Black and Decker replacement part, it is sold individually. The foot is used on all of the workmates shown below. There are four per unit. The purpose of the foot is to keep the unit stable and keep it from moving on the surface it is placed on.

This is a genuine Black and Decker replacement part. It is sold Individually. The part will hold the leg on the Workmate in the down position and lock it in place. By releasing this part the leg can be raised back into the up position.

This item has been sourced from the original manufacturer to be used with work benches from Black and Decker. The slide block attaches to the bottom of the table and is used to allow the table to move across the rails. This item is sold as an individual replacement part.

Genuine Black and Decker replacement part, it is sold individually. This part is used on all the Workmates shown below Its purpose is to open and close the front and rear Vise Jaws on the Workmates. It is held to the vise screw by means of roll pin.

This is a genuine manufacturer sourced replacement part. It is specially designed for use with workmate work benches. Its purpose it to help securing the crank arm to the vise screw. This item is made out of metal and it is sold individually. Normally you should be able to pull out the old roll pin using a pair of pliers.

This axle is an original Black and Decker replacement part manufactured for use with workmate workbenches. The special axle is used as a pin to secure the legs, and allow them to pivot or fold for storage. This axle is sold individually.

This is a genuine DeWALT replacement part. This item is constructed of durable metal, and is compatible with several Workmate and Work Center tables. Legs are fastened onto the four sides of the table base, with foot boots secured on the leg ends. A screwdriver may be needed to remove and replace the leg. This part is sold individually.

This is a genuine Black and Decker replacement part, it is sold individually. The Snap-In Knob is installed in the 242302-00 Crank Handle, on the list of Wormates shown below. Its purpose is to rotate the crank vise to open or close the vise jaws.

This is a Genuine OEM Sourced replacement part designed for use with Workbenches. This item acts as a Support for Vise Jaws. It is made out of Plastic and it is Sold Individually. To replace it you would need a Wrench to remove and secure the Bolts that hold Slide Index and the Vise Jaws.