NOTE: Control board is NOT included. Must be ordered separately.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Refrigerator.
This part works with the following products:
General Electric.
Part# WR17X13200 replaces these:
AP5665853, WR04X10187, WR17X13242
Customer Repair Stories
Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
The Water - Ice selector buttons broke - plastic
Remove two Phillips screws under the edge, slide panel up. Undo two plug in connectors. Remove printed circuit board. Install circuit board into new part and reconnect plugs. Spend the next hour trying to get the panel to slide into place. The new part is molded plastic and does not fit the fridge front and I had to spend hours sanding and trimming the new T slides to fit the metal female T slide receptacles. Unfortunately, the new part does not seem to be an improvement of the old part, so use the buttons VERY carefully as I suspect they will also fail in the future and this plastic replacement part is very expensive.
Other Parts Used:
Edward from MARSHALL, NC
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
21 of 25 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Carol
February 15, 2020
Part 102 not getting the Turbo cool temperature for the top of the refrigerator to a cool temperature
Hello and thank you for writing.
The fresh food temperature will revert to the coldest setting for an 8 hour period or until TurboCool is turned off (whichever comes first). It maximizes the cooling ability of the fresh food compartment. To turn the feature on or off, press and hold the Fridge pad for 3 seconds.
One of the most common causes of a GE refrigerator, not turbo cooling properly is a problem with the self-defrosting functions. The parts likely to cause the problem are the defrost thermostat PS8688283, defrost heater PS6883666 or the temperature sensor PS6883666. We hope this helps. Please contact us anytime if you require further assistance.
The crushed ice push button is stuck inward. Can I replace it without much technical knowledge?
For model number GFE27GSDDSS
Hello Joel, thank you for reaching out. We have found some relevant instructions for installing the dispenser front panel, part number PS6447753. They may not be of the exact same model, but they will help you with the installation. You may follow the following steps:
1. Remove the two screws on the bottom right and left of the inward side of the dispenser panel.
2. Now unclip the front panel from the tabs behind it and pull it out.
3. Disconnect the wires and install the new panel by following the same steps backward.
We hope this information helps!
Was this helpful?
Thank you for voting!
James
January 25, 2024
The water dispenser button is broken. Do I just need to replace the dispenser front to fix it?
For model number GFE29HSDDSS
Hi James, thank you for getting in touch. The water dispenser button is not sold separately, it comes as a part of the dispenser display panel, part number PS6447753. Yes, you may need to replace the entire dispenser display panel to fix it. We hope this information helps!
Was this helpful?
Thank you for voting!
Judi
August 28, 2019
Installing the panel and cant get the lock control and dispenser lights to turn on.
For model number DFE29JSDASS
Hello Judi, thank you for writing. You will want to check the connections of the LED PCB Assembly, part number PS6011772 for your model. If the connections check out okay, you will need to replace the LED PCB Assembly to fix this. Good luck with your repair!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
