Average Repair Rating: 4.4 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
DRYER WOULD STOP EARLY
UNDID THE TOP BACK PANEL SLID FRONT COVER OFF AND REPLACED WIRE FOR WIRE ON TIME-ER AND PC BOARD. TIMER JUST SNAPS IN AND PC BOARD HAS TWO SCREWS TO HOLD IN PLACE. PLACED FRONT BACK IN PLACE AND SCREWED BACK TO BACK PLATE.
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jason
May 5, 2018
Hello, my washer does not enter the rinse and drain cycle on its own anymore. I can hear the suction pump working but the tub does not spin, it does agitate and go through the other cycles on its own. I'm guessing that it's in the timer/selector. That appears to be sold as one with the circuit board. Would you agree that this sounds like the appropriate repair? Thanks in advance!
For model number gcwn5050m1ws
Hello Jason, thank you for your question. I would recommend testing/replacing the lid switch before ordering the board (Lid Switch with Wire Harness Part Number: WH12X10334). Usually if the lid switch doesn't activate, the unit won't go into drain and spin mode. If that is not the problem, the issue is probably with the electronic board itself. I hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
David
March 5, 2019
All the Green lights continuously blink. The bobs or start button will not activate the washer to start a cycle the lights just keep blinking. Any thoughts on what to replace?
For model number GTWN4450M1WS
Hello David, Thank you for the question. This code normally means there is no communication between the motor and control board, Part Number: PS3507656. The control board is most likley the issue and it will need to be replaced. Thank you for your inquiry, good luck with this repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Mike
November 17, 2017
Can i purchase just the plastic mounting hinge that contains the micro switch actuating post and tab (that fits into the rubber button? It is broken - i do not need the complete control board assembly. Thanks
For model number GTWN4450M1WS
Hi Mike,
Thank you for your question. Unfortunately that piece is part of your board. The only way to get that is to replace your board. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
