Average Repair Rating: 3.7 / 5.0, 4 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Top of freezer not cooling properly. Ice cubes melting and allowing ice cycles to form at rear of freezer.
Replaced main control board, located at the rear of unit.
Other Parts Used:
Richard from Bradenton, FL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
33 of 47 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice maker wasn't working right and the freezer wasn't cold enough
-Unplugged the refrigerator -Removed panel on the back of the refrigerator, bottom right. -Took pictures of existing main board so I would know where everything plugs in. -Unplugged and removed main control board -Installed new main control board -Plugged everything in.
Other Parts Used:
Scott from Overland Park, KS
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set
18 of 27 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Overflowing ice maker creating glacier on back wall
No instructions came with the replacement control board. A notice that this part supercedes the original circuit board part number would have been helpful, although it is noted on the web site IF you drill into the parts list deep enough. Diagrams on the web site gave a general location for the circuit board.
Swap-out of the boards was relatively easy, although some of the connectors were reluctant to separate.
The new control board solved the overflowing ice maker issue.
Other Parts Used:
Richard from Florence, OR
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
14 of 22 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice would melt intermittently creating an ice wall on the back or side of the freezer.
Replacement of the Main Control board was relatively easy, although some of the connectors were reluctant to separate.
The new control board appears to have solved the problem.
Other Parts Used:
Don from Herndon, VA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
12 of 19 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
8 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Richard
August 24, 2017
What is motherboard replacment number, my motherboard is wr49x10147 not made anymore
For model number pfss5njwa ss
Hi Richard,
Thank you for your inquiry. The part number for the control board is PS2371144 (manufacturer's part number is WR55X10956). I hope this helps. Thank you and have a great day!
5 people found this helpful.
Was this helpful?
Thank you for voting!
Thomas
August 26, 2017
Would the main control board be able to make the control panels stop working?
Hi Tomas,
That is a good question. If the main control board is not working correctly it can cause the control panel to stop working. There may also be an issue with the touchpad/or controls as well and you will need to test the parts with a multimeter to see which parts are causing the issue. I hope this helps. Thank you and have a great day!
5 people found this helpful.
Was this helpful?
Thank you for voting!
Gary
December 18, 2017
This fridge was transported on its side for 250 miles on a trailer. The fan runs but the compressor does not start. Where should I start looking? Controller board or compressor control box?
For model number PFSF5NJWABB
Hello Gary,
Thanks for your question. The main control board is likely but you may also want to test the part number PS6883663, inverter kit with jumpers. Test the switches with a multi-meter for continuity and replace them if they do not show continuity.
I hope this helps.
My freezer will not stay frozen and water is found on freeze floor and kitchen floor by freezer section. Also refrigerator section temp will reach 42 degree at times when set at 32
For model number pss26pswass
Hi Gene, thank you for your question. When you are having temperature problems in your fridge, there are a few parts that could cause the issue. You can use a multi meter to test most of the parts. Make sure you cut power to your appliance before doing any repairs or tests. First you should test your defrost thermostat. Place the thermostat in ice cold water for 2-3 minutes after removing it from your appliance. It should be reading 0 ohms to be working correctly. Another part to check would be your defrost heater. Remove it from the appliance. It should be reading anywhere between 0 - 50 ohms to be working. You could check your temperature sensor. To find the correct reading for this part you will have to refer to your tech sheet that comes with your appliance. You can usually find this tech sheet behind the bottom grille of your fridge on either the right or left side. These are the most common parts that cause this issue in your appliance. So it is suggested you check them first. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Ayesha
June 26, 2019
After replacing the control board with wr55x10956/wr01f00204, the fan will come on but it will not connect to the compressor. When the old control board is put back it, it makes a connection to the compressor and then turns off but it makes a connection. Should we be looking at a new compressor or another control board?
For model number PGSS5NFYASS
Hello Ayesha, Thank you for the question. This sounds like the board might be defective and shoudl be replaced. Hope this helps!
Was this helpful?
Thank you for voting!
José
January 21, 2020
O painel de controle da porta começou a piscar e parou de funcionar, não mais gerando gelo e liberando água. Qual a solução?
For model number DSHS9NGYACSS
Olá José, Thak você pela pergunta. Você pode tentar descansar o aparelho primeiro desconectando-o por cerca de 5 minutos e depois reconectando-o. Se ainda houver algum problema, talvez seja necessário substituir a placa do dissipador, número de peça PS2374805. Esperamos que isso ajude.
Was this helpful?
Thank you for voting!
Tony
April 10, 2023
Fridge stopped cooling after power went out. Control panel still works and lights. On.
For model number PSH25PSWCSS
Hi Tony, thank you for contacting us. Your refrigerator is not cooling due to a bad temperature sensor, part number PS304103. We hope this helps!
Frig and freezer get to correct temp, hours later temps warm ice melts, hours later goes back to temp. Up and down with temps over a period of hours...will new board fix this?
For model number PFCS1PJXASS
Hello Glen, thank you for the question. I suggest testing the Defrost Thermostat, PartSelect Number PS966762. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. Thank you for your inquiry, good luck with this repair!
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Our scratch-free, streak-free formula removes fingerprints, smudges, grease, dirt and oil, while protecting and polishing to repel dust and dirt. Use on all stainless steel appliance brands and surfaces. Stainless Steel ...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS2371144
Manufacturer Part Number: WR55X10956