Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Claude D - December 4, 2019
Verified Purchase
Easy repair, worked as expected
Part was in a perfect condition and came fast.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.7 / 5.0, 5 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Thru-the-door water actuator (paddle) broken
1) - removed the water tray. 2) - removed the three (3) screws hidden by water tray. 3) - removed entire dispenser faceplate by carefully sliding it up, and then pulling it out CAUTION: there is a ribbon wire connector between the faceplate and the dispenser unit; carefully disconnect. 4) - removed screws retaining the dispenser unit in the door. 5) - disconnect water tube (exit) from the dispenser unit and remove dispenser unit. 6) - carefully disconnect water actuator (paddle) two-wire electrical connector. 7) - remove two small metal "hinge-cover" plates that retain the water actuator (paddle) and remove actuator. 8) - install new water actuator (paddle), reinstall the two small "hinge-cover" plates, connect the two-wire electrical connector, make sure the return-spring is connected to the new water actuator (paddle). 9) - HERE IS THE HARDEST PART - as you reinstall the dispender unit into the door, make sure to reinstall the VERY short water tube back through the dispenser opening - long, skinny fingers would be very helpful. 10) - The remaining reinstallation is pretty straight-forward (the reverse of removal).
Other Parts Used:
Richard from Memphis, TN
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
39 of 44 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
inserting water line back through
I followed the other postings and the only trouble I had was re-inserting the water line tube...like everyone else. After trying several kinds of tape to wrap around and pull the line through the small opening packaging tape did it the first try. Wrap it on an angle and leave yourself a nice long "tail" to pull.
Other Parts Used:
Jeffrey from Tampa, FL
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
12 of 14 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic water actuator snapped in two.
1. Removed exposed screws 2. Removed face plate 3. Disconected wire from switches on face plate 4. Removed screws holding ice/water dispenser 5. Removed screws holding actuator in place 6. Removed wireconnection on actuator (lighted) 7. Replaced broken actuator w/new 8. Replaced all parts in reverse order of removal 9. $300 service call costs me $75 and and 30 minutes of my time. I will always try to fix appliances with the help of PartSelect before calling for service. Thank you!!
Other Parts Used:
Alexander from Santa Monica, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
8 of 10 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken Water Dispenser
I unscrewed the water dispenser and removed the broken piece. Take your time, it is only about 8 screw that need to come out to reach the area for the new part. The only tricky thing about the fix is a spring behind the part. Make sure its lined up, and you should be good to go. Good luck – take your time.
Other Parts Used:
Scott from Fond du Lac, WI
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
4 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken water dispenser lever
Remove screws under tray and trim piece. Lift up and remove face plate. Disconnect flat bundled wires and tape off. Remove ground wires. Remove face plate. Remove dispenser assembly. Remove and replace actuator. Reassemble.
Other Parts Used:
Joseph from Newfoundland, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
3 of 5 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
John
October 14, 2019
Are 241685704 and 241685703 interchangeable besides color?
For model number PHs69EHSS1
Hello John, thank you for your question. They are not shown as interchangeable. The compatible replacement Water Dispenser Actuator for your model is this part number PS1526419 (manufacturer's part number 241685704). Good luck with your repair!
Was this helpful?
Thank you for voting!
Karen
November 3, 2022
our water and ice actuators both broke within weeks of each other is 241685704 compatible with this Electrolux model number
thanks
For model number E23C575DSS4
Hello Karen, thank you for reaching out. The following actuators are compatible with your model: the water dispenser actuator, part number PS1526419, and the Ice actuator, part number PS1526394. Customer service is always available to help you place an order if you are having trouble doing so. Good luck with your repair.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Our scratch-free, streak-free formula removes fingerprints, smudges, grease, dirt and oil, while protecting and polishing to repel dust and dirt. Use on all stainless steel appliance brands and surfaces. Stainless Steel ...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS1526419
Manufacturer Part Number: 241685704