Valve

Hello Chris, Thank you for the question. Yes the PS12349269 is our Part Select part number for the Valve W11101906 Rev B. We hope this helps!

Hi Bill, Thank you for your question. If your washer is not filling with hot or warm water, the water inlet valve is just one part to check. You will also need to check the lid switch, the inlet hoses and screens, the selector switch or water temperature switch, the water level switch and the electronic control board. We hope this helps. Thank you and have a great day!

Hi Ben, Thank you for your question. The screens on a water inlet valve will more than likely become damaged if you try and remove them. You will need to replace the water inlet valve. I hope this helps. Thank you and have a great day!

Hi Ben, Thank you for your question. Number 15 in the diagram is a water inlet valve assembly. The red side of the valve is not sold separately and is only sold with the assembly. To place an order for the part, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.

Hi Greg, thank you for reaching out. First, you may need to make sure that the water pressure is adequate and the inlet hoses are not kinked. You may also need to make sure that the lid locks properly and does not open during operation. If that is not causing the issue, then you may need to check the water inlet valve, part number PS12349269, as it is most likely faulty and may need to be replaced. We hope this is helpful!

Hello Carrie, thank you for getting in touch. According to our research, the water inlet valve screens do not come separately. The screens come as a part of the water inlet valve, part number PS12349269. If you need help placing an order, customer service is open 7 days a week!

Hello Mike, thank you for writing. The Water Inlet Valve tested okay, so you will want to check the Water Tube (part number PS11730901) for cracks and damage that may be causing it to leak. Also check the other water lines to the dispenser. I hope this helps!

Hello Tara, Thank you for the question. If the water is filling even when the washer is not in use, we suggest replacing the Water Inlet Valve as the ports could be "stuck" open allowing water through. If the Tub is just filling while in use but over fills, we suggest checking the pressure hose to make sure it is secure with no soap build up preventing the water from reaching the Pressure Switch. If the Hose is clear, you may need to replace the Water Level/Pressure Switch. We hope this helps!

Hello Jennifer, thank you for contacting us. The most probable cause of the issue is a faulty water inlet valve, part number PS12349269. As you are using well water, we would also recommend checking the washer fill-hose kit, part number PS1803069, and making sure it is not clogged. Customer service is available 7 days a week if you require assistance placing an order. Thanks again for reaching out!

Hi Beth, thank you for your inquiry. According to our research, this problem could be caused by a faulty lid or water level switch. We recommend checking the water inlet valve, part number PS12349269. If this is fine, we suggest checking the lid lock assembly, part number PS12704713. If the issue remains, you may need to replace the electronic control board, part number PS12348137. We hope this is helpful!