Water Inlet Valve

Unplug the A/C plug from outlet.
Turn off the hot and cold water valves.
Disconnect the hot and cold water inlet hoses from the back of machine.
Raise top cover of washing machine by inserting flat screwdriver about 3 inches in from right and left front corners and push against clips. (look in gap between top cover and cabinet to locate exact location of clips.
With 1/4 inch nut driver remove 1 screw holding water valve to cabinet.
With 1/4 inch nut driver remove 1 screw holding water valve to bracket.
Place new water valve in bracket and tighten screw.
Noting orintation transfer wire harness from old valve to new.
Reattach valve bracket to cabinet with one screw.Lower lid.Reattach hot and cold water hoses to valves(note hot and cold). Turn on water, plug in a/c cord. Test to make sure water valve shuts off, and check for leaks where you connected hot and cold hoses.
Congradulations, you saved $160 labor and a discount on the part.


Now remove

unplug cord,disconnect hoses,pop front clips,swing up the top,unplug wires,unscrew bracket with valve,replace valve and reinstall.I did replace hinge because I pulled up to hard the top.

After opening up the washer I found major corrosion on the cold valve. The diagram from the website was very easy to locate and order the part. Shipping was very quick and am happy to say that was the issue and everything is working like normal. Very pleased and recommend to everyone.