Average Repair Rating: 1.0 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Bad Control
Screw driver to get all hold downs loose because there were NO INSTRUCTIONS or online videos' to help with this model. Nut driver for the 1, 1/4 sheet metal screw holding the left side of control. all wires were self explanatory as they only fit in certain spots. Didn't know if it needed any programing after new one was installed , again no videos on this model.
Other Parts Used:
Lee from QUINCY, FL
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Lee
September 21, 2021
Do i need to order stem for knob or can I reuse old one from control on PN
PS10062118
For model number MVWX655DW0
Hi Lee,
Thank you for your question. If the shaft or stem on the electronic control board is broken, then you will need to replace the electronic control board. If you need the knob, the part number for it is PS11756281. If you would like to place an order for either the knob or the electronic control board , you may order them either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.