XSC03Z Makita Circular Saw - Parts

This is a genuine replacement part sourced directly from the manufacturer. The bearing retainer is commonly found in Makita circular trim saws, metal cutting saws, and miter saws. This part is made of metal, and is placed in the bearing box between the bearing and the helical gear. You may require a screwdriver when replacing this product. This item is sold as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The bearing box is found in Makita circular trim saws and metal cutting saws. This part is made of metal, and is used to hold the spindle and allow it to move easily. You will require a screwdriver when replacing this item. The bearing box is available as an individual replacement part.

This part is used in various Makita handheld power tools. It is an authentic part from original manufacturer. A ball bearing facilitates smooth operation by reducing friction while stabilizing and securing moving parts. This part is sold individually.

This item has been OEM sourced to ensure quality. The sealed ball bearing is intended to be used with reciprocating saws, planers, and screwdrivers from Makita. The bearing is used to reduce friction between a rotating shaft and a fixed part assembly. This item is priced as a single part.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less