XRU13Z Makita Trimmer - Parts

It is an OEM item that is made for Makita cordless equipment. This terminal is a specially designed connection point for the 18V battery that powers the tool. It provides an identical replacement for a faulty or a missing component that was installed on a new unit. Refer to the owners manual and the appropriate diagrams for your model to ...Read moreensure the correct repair procedure. Keep in mind this high-quality terminal is sold as an individual item. You will need a screwdriver to take apart and reassemble the housing when replacing this component.

This authentic replacement part which is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, over time components may begin to wear out and fail eventually requiring a replacement. Please note this high-quality ball bearing is made of durable metal and it is sold individually.

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this screw. Note this durable metal screw is sold individually.

This rotor assembly is designed for brushless cordless outdoor power equipment to support smooth, efficient motor operation. Built to precise standards for proper fit and balance, it helps restore power output while reducing vibration during use. It’s a practical replacement for maintaining reliable performance and extending the service life of brushless string trimmers.

This is an OEM receive washer found in outdoor power equipment. This part is manufactured by Makita and is guaranteed to fit. The receive washer sits between a ball bearing and O-ring inside the motor housing set. If the washer is bent or damaged it will need to be replaced. The housing will need to be removed to access this part.

This cutter part is an OEM Makita part for a trimmer. It is located in the trimmer head underneath the protector. It is secured in place by two 4x18 tapping screws. It is made of metal and measures approximately 1-3/4-Inches long and 3/4-Inches wide. Due to frequent use and exposure to so much dirt and debris, it tends to wear over time and will need to be replaced.

This is a genuine guard for string trimmers. The guard is made of steel and is silver in color. It is round with an opening in the middle. It fits on top of the receive washer and is part of the motor housing. It is sold individually.