All Installation Instructions for Westinghouse Refrigerator WRT8G3EWR

lunchmeat drawer support rail broke

husband did it in less than 3 minutes. took top shelf out with part attached. one little screw to remove broke piece and one screw to install replacement part, good as new. took longer to clean the shelf before replacing it back in fridge.

Parts Used:

Drawer Support Rail - Right Side

Stacy from Chisholm, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Door retainer bars were broken

Pushed down on bar slots

Parts Used:

Door Shelf Retainer Bar

Sheryl from TOMPKINSVILLE, KY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The door shelf retainer bars cracked.

The repair was quick and easy. I simply removed the old/cracked door shelf retainer bars and snapped the new ones into place.

Parts Used:

Door Shelf Retainer Bar

Deidre from FONTANA, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

5 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Top cools bottom is weak

Unplug, remove 2 screws off back panel inside the freezer. Cut wires on old one and crimped in new one. Light to melt the shrink wrap that came with it. Pretty easy.

Parts Used:

Defrost Thermostat

JUSTIN from NEW BRAUNFELS, TX
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Freezer iced up and no cold air in lower potion of refrigerator.

Simple repair and less than 30 minutes.
But the video you had was taken down which showed you need to wind the timer. I called and was promptly sent another video, thanks Ashley !

Unfortunately the second video did not mention that you have to wind the timer, like the first video did. Turn clockwise till you hear 2 clicks.

All good. 20 year old fridge chugging along.

Parts Used:

Defrost Timer - 120V 60Hz

David from COLLEYVILLE, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Fridge was cooling down enough the heating defrost was bad

I take 2 crew on front of the fridge take the cover and fan out replaced the part and put everything back it’s a easy job thanks guys for the parts from Orlando fl

Parts Used:

Defrost Heater

José from ORLANDO, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator door gasket was cracked along the top edge

Super easy fix! Used flathead screwdriver to start corner of gasket, then just pulled it out with my hands. Cleaned the track and surrounding area with a rag and some windex. Started in top right corner with new gasket and just worked my way around the door until it was fully seated in track. Done! Only thing I would do differently next time would be to start at the bottom when installing new gasket, just so I could have better sight and leverage at the end.

Parts Used:

Refrigerator Door Gasket

Carla from SALEM, VA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The door gasket was not working at all

I watched and followed the instructions on YouTube ?? very easy

Parts Used:

Refrigerator Door Gasket

Bobbie from ARLETA, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Seal damaged

Simple instructions anyone should be able to do it.

Parts Used:

Refrigerator Door Gasket

Dean from STILWELL, KS
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Repaired Oven Range Light Bulb

The bulb has a plastic clear cover. That cover can just be carefully removed using a screwdriver. It's held in by a metal bracket. After you remove the cover. You'll just need to replace the bulb and then re-install the cover and bracket.

Parts Used:

Light Bulb

Alan from SAN MATEO, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Accidentally broke the glass insert.

Simply slide the new glass insert in!

Parts Used:

Crisper Glass Shelf Insert

DAVID from SAN FRANCISCO, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

broken glass on top of crispers

Since the glass was broken and gone I just had to slide the new glass on top of the crispers. This was not really a repair, just an exchange of new for the old.

Parts Used:

Crisper Glass Shelf Insert

Teresa from SOUTHFIELD, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The original part was plastic/and broke

unscrewed to little bolts and installed the new/metal part we got rfom partselect.If we may say.this is a great company to buy from! Fast!

Parts Used:

Upper Hinge

John from Lancaster, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

fan blade broke

Received fan blade part took about 5 min to install and running great.

Parts Used:

Fan Blade

Kevin from ST PETERSBURG, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Both parts were broken.

I followed the instructional videos I found here on PartSelect.com. They were accurate and easy to follow. The new parts were installed and the shelf was reassembled in a matter of minutes. Good as new.

Parts Used: