WRF767SDHZ01 Whirlpool Refrigerator - Instructions

Unplug refrigerator.
Pry switch out with putty knife
Remove two wires from switch
Attach wires to new switch
Push new switch into slot

Popped out broken switch with blunt flat edged instrument. Disconnected switch from unit . Plugged new piece in and reinserted into side panel of refrigerator. Very easy.

use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks

Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.

Disconnect plug from wall. Insert putty knife between light switch.and trim panel , apply pressure to depress plastic spring holding switch in place. Apply a slight twist too putty knife releasing switch from trim piece. This wil expose plug connected to switch. Disconnect plug from switch. Connect new switch to plug. Insert switch into trim. Plug refrigerator into wall socket.

The instructions in the package were not helpful. They wanted me to cut the wiring harness and described where to cut based on the wire colors. My wires were not the same color! I removed the light mechanism using a combination of a screwdriver, putty knife, and plain old muscle with my fingers! The wiring harness unplugged easily and the new one inserted. It was easy to push the whole assembly back into the door. I spent more time looking for something to cut the wiring harness with (and never did find it) than the whole job actually took without needing to cut anything!

I took a chance and ordered a switch that is next to the top of the door. looked for how to remove it easily done in ten minutes works fine last long time.

Simply placed on the front

Once I got a part that wasn't broken in transit (took them sending it 3 times for that to happen), it was a breeze. Remove old drawer, take tracks off old drawer and place on new drawer. Put new drawer in fridge.

Removed old door. Attached new door to two tabs. Done

I used the video step by step. The video showed complete process to swap out the motor. It was very simple to do.

I found the web site and the pictorial schematic of the refrigerator but it really didn't show the part as well as I had hoped, so I called the toll free Partselect number and spoke with a representative who took down all of the information and told me the part would be shipped out in a few days. Well, low and behold the next day Fedex was delivering this ling box to my door-I carefully opened it-it was the front cover plate of the drawer BELOW the broken one-perhaps my mistake in explaining it properly over the telephone-so back to the toll free number to try and straighten out the problem and reorder the correct part-that was even simpler than the first call-the correct part was ordered, return Fedex paperwork was sent to me via email, and several days later the correct part did indeed arrive. Installation took probably a total of 5 minutes or less-the old cover came off effortlessly (it was half off anyway) and the identical new replacement simply snapped into place and..............wah-lah as they say-back in business. It was a pleasure to do business with this company-their staff is courteous and efficient-and oh, yes, the first shipment was indeed picked up by Fedex when they delivered the correct package and was credited back to my credit card as promised. Thank you for being there Partselect.
John Reid
Cape Coral Florida

We removed the old switch, unplugged it, plugged the new one in and it was easy to do. But when we tried to put the switch back in we had a very hard time doing it. Eventually got it in, but if it had not been for the difficulty we had getting the new switch to snap in to place, it would have taken under 5 minutes.

With a screwdriver and a lot of time

Just plugged it in