TDB210RFS0 Tappan Dishwasher - Parts

This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be replaced to keep water from leaking out on to the floor. The gasket is approximately 23” long and is a genuine OEM part. It is recommended that once you have in...Read morestalled the gasket to leave the door closed for a few hours to make sure the gasket is properly sealed.

This dishwasher water inlet valve is a genuine OEM component designed to regulate water flow into the appliance during the fill cycle. Typically located behind the lower kickplate panel in either front corner, the valve uses solenoids to open and close, ensuring the correct amount of water enters the tub for effective cleaning. Operating ...Read moreat 120 volts and 60 Hz, this part is essential for maintaining proper dishwasher performance. Common symptoms of a faulty valve include leaking, failure to fill, poor cleaning results, or incomplete draining. Installation requires disconnecting power and water supply, and a flat blade screwdriver may be needed to access the valve. Always verify model compatibility before purchase.

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is mad...Read moree of white plastic, and clips to the dishwasher rack with the included axle/clip. Many of our customers have described this repair as easy, and you will not require any tools to complete it. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.

This lower spray arm assembly is a vital component in your dishwasher, responsible for distributing water and detergent throughout the tub during the wash cycle. Its rotating motion ensures thorough cleaning by spraying water in multiple directions. Typically mounted to a hub at the bottom of the dishwasher, a damaged spray arm may cause ...Read moreknocking sounds, restricted rotation, or poor cleaning results. Replacing it helps eliminate food residue and unpleasant odors. Installation is simple—just lift the center of the old arm to release it, and snap the new one into place. This OEM part is sold individually.

Sold Individually.

This nut is sold individually. It is used to install the heating element.

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long

Sold individually. Grey in color.

This linkage attaches to the door spring.

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

The pump ejects the water from the dishwasher.

The tubing carries water from the water inlet valve to the tub.