TD0101F Makita Impact Driver - Parts

It is a genuine OEM supplied replacement flat washer which has a few different applications depending on the tool, make sure to check appropriate diagrams for correct location and use of this hardware. Please note this part is made from high quality metal and it is sold individually.

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Makita power tools. The purpose of the brush cap is to secure the brush in the housing, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality cap is made of durable plastic and is sold individually.

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

This is an authentic replacement part manufactured for use with Makita drills/drivers. The flat washer is commonly used to provide a wider surface area for the pressure put on the spring ring by the compression spring on the spindle. This flat washer is available as an individual replacement part, please see model diagram for associative parts.

This replacement ball bearing is an authentic Makita item. It is supplied directly from original equipment manufacturer for use with angle grinders. Please check diagrams for proper application of this item. The bearing is specially designed to reduce friction between rotating parts. Over time it will wear out and will need to be replaced...Read more. This is a sealed metal bearing and it is sold individually. Included in part number 515616-3

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

The ring spring goes next to the flat washer and is made of metal. It is priced as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with Makita drills, impact drivers, and screwdrivers. A set of pliers may be necessary during the installation of this part. It may become broken and will need to be replaced.

This is a Genuine OEM replacement part used on Makita drills and drivers. This is a metal spring and it is sold individually. Over time springs may lose its tension and may not function as intended. If this part is lost or damaged it must be replaced. To replace this spring a pair of pliers is needed.

This cord protector is an OEM part designed for a variety of Makita power tools. It is attached where the power cord meets the tool. This part protects the cord from damage due to pulling, bending, or other strain. This rubber cord protector is sold individually. It does not include a replacement cord.