SHS5AV56UC (22) Bosch Dishwasher - Instructions

pushed with thumb pressure and snapped rollers into place.....EASY

There were 5 rollers still in place so I used them to show me how to snap the replacement roller in place.

Remove the dishwasher from under the counter. Remove door springs. On the inside of the lip of the door remove the 6 screws that hold the outer door panel on, and remove panel. this will expose hinge screws. Remove the two screws per side holding the inner door to the hinge assembly. Take pictures of the way the gasket's grey plastic end cap assembles between the inner door frame and the hinge, and remove the inner door. The old gasket has a channel lip that sits on the plastic edge of the washer tub, pull it off this lip and discard. Install new gasket and put it all back together! Use this opportunity to clean the gunk out of the upper door seals.

I watch utube to assess the problem then took eveything apart and saw the build up on the filter, which i had never cleaned. I tried to clean it but was unsuccessful so order the filter from partselect and it came within a couple of days, installed very easily and began to clean as it always had.

Really simple. You pull out the drain filter plate and pull the filter off the support and replace. I gave everything a good cleaning and put it back in place.

This repair was relatively easy and saved us literally hundreds of dollars as well as time...we were looking at 3+ weeks for a technician to come out. And that was just to diagnose. The hardest part was my own lack of experience and getting the dishwasher out because of a poor installation. The best part was identifying and ordering the part from PartSelect. The part came quickly...within 2 days. I had ordered a wrong part previously and they took it back no problem. Very pleased with the whole process and their help videos.

Replacement was fast and very simple. Was completed in less than 5 minutes.

replacing the sensor was simple, just unplug and turn it out, but didn't solve the problem, it's a float sensor that doesn't show up on the tech sheet in the dishwasher or anywhere in troubleshooting on the internet I could find.

We followed the video and had no problems with leaks at all afterwards. The parts fit perfectly and the machine is working great again.

Mistakenly opened covers for the drain pump. Had to put those covers back in place.
Heater and pump installed easily with a bit of careful maneuvering the plugs and plug housing from the exterior. Pump installed in place easily. Clamp fit perfectly.

I bought replacement wheels.
I put them on the post, and they snapped onto the vertical post very easily. Job done.

easy repair, but the check valve wasn't the problem, it was the float switch that isn't on the tech sheet in the dishwasher or mentioned as a possible culprit anywhere I could find on the internet

Popped the new one right on!

My son and my husband did it. I watched.
They both injured their fingers.
But it stopped the leak!