S32SLLM Bostitch Nailer - Parts

This is an OEM part sourced directly from the manufacturer. The head valve spring is designed for use in staplers and nailers from Bostitch. This part is made of metal, and is used to provide tension between the head valve and the piston stop bumper. You will require an Allen wrench or hex key when replacing this part. This item is sold individually.

This o-ring is a genuine Bostitch replacement part, it is not an aftermarket imitation. It is specially made for staplers and nailers. This o-ring is used to provide an air-tight seal for the sleeve. Over time these rubber parts will deteriorate and crack requiring replacement. You will need a hex key also known as an allen wrench to replace this o-ring.

This is an authentic replacement part manufactured for use with Bostitch brad nailers and pneumatic staplers. The special gasket forms a seal between the end cap and the frame. This gasket is sold as an individual replacement part, please see model diagram for associative parts.

This is an authentic manufacturer-sourced replacement check seal which is specially designed for use with Bostitch nailers and staplers. It is the component which helps to provide an air-tight seal for the cylinder sleeve, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this ...Read morepart. Over time it may wear out and begin to crack eventually requiring a replacement to ensure peak performance. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

It is a genuine manufacturer-supplied component which is made for Bostitch nailers and staplers. This is a special spiral pin that is utilized to secure the trigger. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. To ensure the proper repair procedure, refer to the appropriate diagram fo...Read morer your model. The spiral pin is made of durable metal and is sold as an individual item. You may need pliers to replace it.

This compression spring is an OEM direct from Bostitch. The metal spring is compatible with many stapler and nailer tools. This item is fitted within the trigger valve kit of the device. The spring is the mechanism for the trigger to move back in place. Although this part is sold individually, it can also be found in the SEQ6 Kit. A small hammer and a hex key are helpful in the repair.

This o-ring is a high quality item designed for Bostitch nailers and staplers. It is an authentic part that is supplied directly from original equipment manufacturer. This o-ring is generally used to provide a seal for the trigger valve. Over time these rubber parts tend to shrink, become brittle and crack allowing for air leaks. Keep an ...Read moreeye on the tools performance and replace o-rings as needed to maintain optimum performance. Please note, one rubber o-ring is included per order. Replacing this item you will need hex key also known as an allen wrench.