RY43160A Ryobi Pole Saw - Parts

This is an authentic OEM part and is specially designed to fit a Homelite or Ryobi electric pole saw. The oil tank assembly holds the oil that is needed to run the machine. This is made of a durable plastic does not include the oil cap part number 34117152-3G sold as the tank only.

The switch goes next to the tube. It is made of metal and plastic and is sold individually. This item is an original part from Homelite and Ryobi for use in saws and trimmers. A screwdriver might be required during the replacement of this part. It will require replacing if it becomes broken.

This manufacturer approved replacement part is designed for use with electric pole saws. This assembly includes a metal brush holder, one (1) carbon brush with a lead wire and a spring attached. Due to constant contact with an armature brushes will eventually wear down and will need to be replaced. It is advised to replace both brushes a...Read moret the same type. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems. You would need a screwdriver to complete this job. • Remove the screws from the housing • Separate housing to gain access to armature and brushes • Remove old brush assembly and replace it with a new one • Re-assemble and test the tool

This is a genuine replacement part manufactured for use with pole pruners. The special bar stud is used to secure the bar guide and the chainsaw part itself. This bar stud is available as an individual replacement part, please note two bar studs may be required.

This oil filler cap is specially designed for use with pole saws. It is used to keep the oil in the tank. A damaged or lost filler cap should be replaced before the unit can be operated. It is made out of yellow plastic and it is sold individually.

This is an OEM part sourced directly from the manufacturer. The rubber pad is found in pole saws from Homelite and Ryobi. This part is placed against the motor assembly to prevent vibration and unnecessary wear. You will require a screwdriver when replacing this item. This part is sold individually.

This genuine manufacturer sourced replacement part designed for use with pole saws. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. It is used to secure the chain cover assembly. This lock nut is made out of metal and it is sold individually.