RUD4000SQ1 Roper Dishwasher - Parts

The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes properly, the rack stop may need to be replaced. The replacement part may differ slightly from the broken part, depending on the model. However, the different s...Read moretyles are interchangeable. This product is sold individually and comes in both a white and grey plastic version. Many of our customers found this repair to be very easy and takes less than 30 minutes to complete. Simply snap the old part out and snap the new part into place. You will not require any tools to complete the job. This is an authentic part approved by the manufacturer.

Sold Individually.

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and lea...Read moreve it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.

This metallic spring is for your dishwasher's soap cup cover. Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. It may be a different color, and you may need to order an elbow (# W10685193) for the new designed valve to work.

This cap does not require the use of a o-ring seal.

Sold individually. Used with the heating element.

7-18 x 3/4-Inch - sold individually.

The lid hinge pin or detergent lid pin on your dishwasher helps dispense your dish detergent when your dishwasher is running. The pin fits with the dispenser lid and allows the lid to pop open and dispense detergent. It is a small, plastic pin that is approximately 3 inches in length. Due to its small size, the pin can be damaged relative...Read morely easily, and if your pin is broken or missing, it will need to be replaced. This product is sold individually.

Sold Individually - 4 required on rack.

This part covers your soap dispenser and is spring loaded.