RF267ACBP Samsung Refrigerator - Instructions

I removed the old spring along with the sleeve and inserted the new one in its place. used a small screw driver to remove the sleeve and inserted the sleeve side in first. took 5 minutes..

Spent a dollar 1.97 on the spring.7.00 on shipping and fixed it in less than 5 minutes.Fantastic

Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.

Placed one end of the new spring in left hole and used the needle nose pliers to insert the other end of the spring in the right hole.

replacing broken french door spring.

Held spring with needle nose pliers and slipped into place

The website offered next day delivery on the 2 parts I needed. It was $30 dollars for next day but I wanted it fixed so I chose it. After a few days I revived no parts. I checked the website and saw the 2 parts were on back order, however they took my payment along with the $30 for next day delivery. Obviously I never got it next, or ever ... Read more , so I cancelled the order. At least I got my money back.

Replaced the spring on my French door refrigerator
Was super easy

Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.

had to replace the spring on the Mullion door . the how to video helped however the demonstration shows putting the spring on in the opposite way that my door calls for, so just I turned the spring around and done, other than that easy as pie.
thanks
Chris F.

Very carefully used the pliers to put the spring in the two slots with the door mullion. Works like brand new

Lifted out the broken part and replaced with new spring.

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

pushed new spring in.

(1) Set ice production to OFF from the front panel of the refridgerator. (2) Inside the fridge, remove the screw holding the panel covering the cable for the ice naker assembly. (3) Remove the panel. (4) Disconnect the power cable of ice maker. (5) Holding the assembly with one hand, release the locking clip of assembly housing, and slide ... Read more assembly forward until it is free. (6) Remove the ice maker assembly. (7) Install the new assembly by reversing the previous steps. (8) Reset the ice maker by pressing the reset button and holding it for at least 8 seconds. The first time the ice maker is primed with water, there are 2 chimes. (1 High , 1 Low).