REFSVC Samsung Refrigerator - Instructions

Placed one end of the new spring in left hole and used the needle nose pliers to insert the other end of the spring in the right hole.

After purchasing the spring I realized the hinge was the culprit. It has the retainer for the spring as part of it, a small plastic piece that broke off cause the spring to get lost. The hinge replacement was a little more in depth but the video on the hinge is very good and on point.

Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.

I removed the old spring along with the sleeve and inserted the new one in its place. used a small screw driver to remove the sleeve and inserted the sleeve side in first. took 5 minutes..

Spent a dollar 1.97 on the spring.7.00 on shipping and fixed it in less than 5 minutes.Fantastic

replacing broken french door spring.

Held spring with needle nose pliers and slipped into place

had to replace the spring on the Mullion door . the how to video helped however the demonstration shows putting the spring on in the opposite way that my door calls for, so just I turned the spring around and done, other than that easy as pie.
thanks
Chris F.

Replaced the spring on my French door refrigerator
Was super easy

Very carefully used the pliers to put the spring in the two slots with the door mullion. Works like brand new

Replaced the Broken Cover Motor and the Fan Blade. Fan motor was test with 12VDC power supply, or by replugging fan connector and holding down the door closing switch.

After a few days, the fan made loud noise. Due to defrog heater was open when it was test with ohmmeter. Ice deposited around the fan.

I had to buy ... Read more a whole ASSY EVAP-REF part # DA96-00395C, and seperated the evaperator, and replaced the heater and sensor.
Spray bottle was used spray hot water to de-iced the evaperator. And salt accelerated the ice melting process.

Note: spray water to clean salt before installing new parts

Lifted out the broken part and replaced with new spring.

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.

pushed new spring in.