PDW1800N00WW General Electric Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
bottom door gasket replacement/door latch replacement
Need to remove door from hinges to allow to SLIDE gasket thru small lip on door.After using soap and cleaning lip on dishwasher face ,Gasket never feels to grasp lip properly.Identical gasket from old design,just difficult to install.Door latch was also easy to install,BUT LATCH WAS PURCHASED IN LOCKED POSITION.Make sure to roll tumbler in latch ,or it will never lock.
Parts Used:
-
CHUCK from CINCINNATI, OH
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
4 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken upper roller
Turn water and electric off. remove\ dishwasher
take of old roller mount and replace new part
0
take of old roller mount and replace new part
0
Parts Used:
-
Inge from ANAHEIM, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Socket set, Wrench (Adjustable)
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaking drain hose
Removed leaking drain hose under the dishwasher from drain pump and sink drain pipe. Fed new hose behind dw connected with new clamps to dw drain pump and sink drain pipe. Put in high loop under sink.
Parts Used:
-
Vivian from RAMSEY, NJ
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
needed new silverware basket
-
CAROL from BUFFALO, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Roller wheels wore out.
manual labor.. And a little help from Milwaukee power tools.
Parts Used:
-
Michael from Gwinner, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
4 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lower rack wheels kept falling off on right side
Definately purchase all the wheels (8) as they are smaller than original wheels. Buy the wheel with attached stud. Pull off old wheels and pop these on!
Parts Used:
-
Mary from Rocky River, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
the lower rack wheels were breaking
I was able to replace the wheels with the new ones I ordered which are a better design.
Parts Used:
-
Nonie H from Kitty Hawk, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Wheels Had Fallen Off
The wheels on our bottom tray to our dishwasher had fallen off from a lot of use here in our office. When the wheels arrived, I just simply snapped them back on. A few had to be snapped on tight, but there were no tools necessary. Overall, a very easy fix.
Parts Used:
-
Crown Agents USA from Washington, DC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Studs had become worn and needed replaced
Removed all wheels, then removed and installed new studs which were designed better than the origional and re-installed. Bottom rack now slides in and out much better.
Parts Used:
-
Scott from Newark, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Seals and Wheels
It was really easy to find the parts in the diagram your website provided. Youtubed the repair instructions....done....thank you very much
Parts Used:
-
Danielle from Fort Edward, NY
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The wheels were falling off from the bottom rack of my dishwasher.
I ordered 8 wheels, but I really needed just 4.( I am preventing for the future) It was so very simple to place my order and they were delivered in no time. I simply took off the old one, looked at how they were affixed and put the new ones the same way. Less than 2 minutes to do the entire job. I am a "Handy woman".
Parts Used:
-
Colette from Lakewood Ranch, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher basket worn our and utensils slipped through bottom
1. open dishwasher, 2. roll out bottom dish rack, 3. remove old silverware basket, 4 place new basket in same spot old basket was in, 5. roll bottom dish rack back into dishwasher, 6. close dishwasher door.
Parts Used:
-
EUGENE from CENTEREACH, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Rubber gasket for sealing top sprayer arm worn out
The repair piece containing the gasket must be unscrewed and the replacement piece is then screwed into place. Use of a wrench is necessary but used gentle compression as this piece is plastic. Also be careful when starting to thread the piece back on as too much pressure may push the part you are threading it onto out of the back of the dishwasher. ( Note that removing the top rack facilitates the job.. This is done by pushing the locks at the end of the roller tracks in and then to the side, opening the tracks for removal of the rack.)
Parts Used:
-
J from Johnson City, TN
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!