MVWB765FW4 Maytag Washer - Instructions

I watched a YouTube video first. Followed instructions exactly and had washer going in 30 minutes!!!! Part that I ordered was an exact fit! Thanks to partselect.com!

Removed three screws on back to open top panel, used small vice grip to pull on suspension rod to unhook and remove from the drum. Remove and replaced one at a time so the rods keep drum suspended and prevent from dropping in the cabinet . Reinstalled top panel and done .Very easy completed in about 20 minutes.

UNPLUG WASHER FROM WALL PLUG
Watch u tube on how to remove top and also cover on top circuit compartment
First find the service book taped inside front. PLUGand read to read codes
call up the error codes flashing
the code indicated a defective lid latch.UNPUG WASHER
went through testing the switch one of the contacts was defective and intermittent.
UNPUG WASHER unpug J connect from circuit board remove wiring and connect from lid
new wiring harness goes back same as old one and mount new lid switch. done

Used some essential oils in laundry to help with odor. (Doesn't work, don't bother. Just get better soap.) Oils caused damage to center dispenser tray. Bought replacement tray. Simply pull the old one out by pushing down on the tabs on each end, slide the new one in place. Maybe took 30 seconds. Price? Far too expensive for a plastic drawer, but what do you do?

move washer to get to backside, remove necessary screws and hoses, slid washer top over, replaced lid mechanism.

Replaced each hose. Did discover that either hose can be used for hot or cold water lines. No longer required to label hot and cold replacement hoses.

My husband watched numerous YouTube videos before tackling it.

The video was excellent in what needed to be accomplished. However it showed reaching inside the tub with vise grips to grab the old spring. This worked fine for removing them but the installation of the new spring did not allow my hand and vise grip to secure the new spring and pull it up and insert it into the retainer. I found that by taking a cord and putting it through the socket and retainer allowed me to pull straight up and seat it in the retainer a lot easier.

Take the old one out and put a new one in

I was sent the wrong part , when I questioned them said they did not have it so was directed to Whirlpool and they are making it and I might get it in May

Popped the cap , used a socket to unscrew the bolt (it was stripped so ended up having to cut off bolt) Took off old impellar and replaced, installed a new bolt, replaced Cap and it was fixed.

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

At first I had to position the washer so I could get access.. after having it positioned, I figured it out. Getting the clamp fastened, I was done.