MHWE450WR01 Maytag Washer - Parts

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub. Clamps are not included. NOTE: Must order clamps separately, if needed.

If your washer isn’t draining properly or is leaking water, this drain pump could be the fix. It’s made for front-load models from Whirlpool, Maytag, Kenmore, and more. The pump helps remove water during the wash cycle and keeps your machine running smoothly. Common signs it needs replacing include loud noises, drainage errors, or water left in the drum. Just check your model number to make sure it’s the right fit.

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Sold individually. These shock absorbers keep the washer from vigorous shaking during its cycles. This shock absorber is for washers. Shock absorber absorbs the vibrations and movements of the outer washer tub. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Designed for front-load washers, this door hinge connects the door to the appliance body and allows it to pivot securely. It’s a genuine replacement part that helps fix issues like misalignment, loose movement, or doors that won’t stay closed. Compatible with various models and easy to install.

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

Sold individually. Baffle only. No screws are required. The baffle has hooks that slide onto the basket.

Used to help hold your bellow in place on your washer.

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow ...Read moreinto place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

This hose goes from the drain pump to the back of the washer.

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.