MH1170XSQ5 Whirlpool Microwave - Instructions

Removed 2 screws on the top of the microwave and removed top/front piece of microwave. Slid out old filter (which didn't look dirty at all) and replaced it with the new one. Replaced top/front piece and 2 screws. It took less than 5 minutes.

unscrewed the screws and put the new vent in

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey

Tray arrived in a short period of time and was a perfect match.

FOLLOWED EASY INSTRUCTIONS VIA THE WEB.Note: I am a widow...83 yrs of age. Thanks for making it easy!

The filter was just a maintenance issue. The vent grille, as described on the website already, is poorly constructed; the plastic where the screws attach to hold it on break easily. I ended up using something similar to the plastic of a credit card to make a repair to the side that had broken. I ended up not installing the new grille, I thought I would see how the repair I made held up first. I kept the grille as a spare when the old one finally breaks. CAUTION: When you clean the grille, take it off first! The two spots where it attaches are cheaply made and will break easily. Take out the two screws, clean the grille, and then put it back into place. DO NOT OVER TIGHTEN THE SCREWS! Tighten them just enough to hold it in place.

Removed the glass cover and replaced the bulb. Very simple.

I had no problem installing the new filter. Just used a phillips screw driver to remove the two screws holding the vent cover in place. Cleaned the dust out of the ducts and reinstalled the new filter. The screws must be held to the screw driver with your finger tips so you don't drop them in the vent cover. The most difficulty I had was in clearing the clean code from the screen. There are no instructions in the owners manual for doing this. But after several tries I got it.