MDG12CSAAL Maytag Dryer - Parts

This front or rear dryer drum felt seal is seventy-nine and a half inches long.

This idler pulley shaft washer is used with many clothes dryers. It is less than an inch long, and it is black in color.

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and ...Read moreis made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

This part replaces older two terminal switches.

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This dryer drive motor is a genuine OEM replacement part designed to power the drum rotation in select Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, and Magic Chef dryers. Operating at 115 volts and 60 Hz with a 1/4 horsepower output, it drives the belt that turns the drum, ensuring consistent and efficient drying performance. The updat...Read moreed motor features a redesigned switch and new wire terminals, which may require re-wiring during installation. Common symptoms of a failing motor include the dryer not starting, the drum not turning, or the appliance stopping mid-cycle. Installation should be performed by a qualified technician, and it is essential to verify compatibility with your specific model before ordering. *Note: part does not come with installation instructions

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This idler shaft retaining ring is well under an inch long and is made of metal.

This screw is sold individually.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you will have to replace it when it blows.

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.