MDG10CSABW Maytag Dryer - Parts

This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and it is recommended to change both at once.

The tumbler and motor belt in your dryer allows the drum to spin during the drying cycle. At 100 inches in length, this dryer drum belt is 3/8 of an inch wide and has five ridges. The belt is black in color and it is made entirely of rubber. If your dryer will not tumble, is noisy during operation, or will not start you may need to replac...Read moree the belt. To complete this repair, you will need to remove the front panel as well as the drum. You will need a 5/16 nut driver and a stubby Phillips screwdriver to complete the repair. Be sure to disconnect power to the dryer before you begin this repair. During the repair, make sure the belt doesn't fall into the groove in the drum, which will cause it to be too loose. You should be able to access the belt and replace it by removing the front panel and bulkhead.

This roller shaft is the axle for the drum roller, also known as drum roller axle.

This front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. Two kits are required per appliance. A rivet tool is required for this installation.

This blower wheel comes with a metallic hub clamp to hold it firmly in place.

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.

This metallic retaining ring is less than an inch in diameter. It is made entirely of metal.

This filter collects lint as it passes through the dryer vent.

This roller shaft washer is just under an inch in diameter and is used for some of Whirlpool's brands of clothes dryers.Sold individually.

This flat style igniter comes with a wire harness connector. This part ignites the gas within the dryer. Bracket is NOT included.

This part is used to help the belt to rotate the drum. It is white and made of plastic with a metallic bearing in the center.

This kit comes in two pieces: the catch and the clip.