MDE12CSACL Maytag Dryer - Parts

This part replaces older two terminal switches.

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This dryer drive motor is a genuine OEM replacement part designed to power the drum rotation in select Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, and Magic Chef dryers. Operating at 115 volts and 60 Hz with a 1/4 horsepower output, it drives the belt that turns the drum, ensuring consistent and efficient drying performance. The updat...Read moreed motor features a redesigned switch and new wire terminals, which may require re-wiring during installation. Common symptoms of a failing motor include the dryer not starting, the drum not turning, or the appliance stopping mid-cycle. Installation should be performed by a qualified technician, and it is essential to verify compatibility with your specific model before ordering. *Note: part does not come with installation instructions

Keep your dryer safe and running smoothly with this high-limit thermostat. It shuts off the heat when things get too hot—around 200°F—and turns it back on once it cools down to about 170°F. This helps prevent overheating and keeps your laundry routine worry-free. With two easy-to-connect terminals, it fits many dryer models and installs quickly with basic tools.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This idler shaft retaining ring is well under an inch long and is made of metal.

This screw is sold individually.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you will have to replace it when it blows.

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

If your dryer isn’t heating properly, this adjustable thermostat kit could be the solution. It helps keep the dryer at the right temperature by turning the heat on and off as needed. You can set it anywhere between 135°F and 155°F, and it kicks the heat back on when the temperature drops by 20°F. The kit comes with everything you need—the...Read morermostat, jumper wires, and wire nuts—and is a great fix for dryers that aren’t warming up like they should.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.