MAV8757AWQ Maytag Washer - Instructions

I changed the piece easily

I removed top control panel and then the old power cord that been damaged by a small fire and the just attached the new power cord and control panel. Unblievably simple and I saved myself a lot of money. Where I live in a NYC suburb this type of simple repair could easily cost $100.

Took off back cover an belt replaced part

Followed the great instructions on your video

Disconnect Power. Disconnect supply hoses. Open top by releasing top retainer clips with a thin blade or putty knife. Remove 2 sheet metal screws retaining front cover. Remove front cover. Lay a blanket on the floor and lay the machine over on its side leaving access to the front where the panel was just removed. Take belt off. Remove pump hose at bottom of drum. Prop up drum so it is centered in its normal position and not laying to one side. Do this near the lid end. Remove all centering springs - carefully. Drum and transmission assy will now come out through the front opening. Flip drum assy upside down with transmission up. Loosen the screws (do not remove completely - WARNING OF 200 LBS SPRING LOAD!) that clamp the snubber ring to the transmission. Remove the old snubber ring and replace with new. Be sure it is completely under the flange all the way around. Tighten the retaining ring screws. Reassemble all parts in reverse order. Done. Be sure to level the machine per owners manual instructions.

I followed the instructions that other posters suggested. The springs were the toughest part to remove and reinstall. Having my wife push the tub enabled me to use vice grips to get them back on. Read about the coins or washers to spread the springs too late... would have helped. Running a wash now and it's spinning great and no noise!

Replaced pump because pulley did not come off pump without breaking pump in half.

Tipped the machine against the wall. This exposed the belt which is not inside the machine. Took the old belt off put the new one on.

The repair was a piece of cake! I actually stumbled upon PartSelect by searching for the part, it happened to be that the part through your company was the cheapest! Not only did that make me and my wallet happy the part came fast and i was able to repair the washer in 15-30 mins!! Thank you PartSelect!

Replacing the water pump only required the removal of the front Panel, removing and replacing the pump with socket set and then installing front panel with the new clip. Once this was complete the belt drive was installed on the bottom of the washer. Very easy fix.

All I had to do was take off the white cap on top of the spinner, place the dispenser cup in the hole and it was done! It works great even though there was no indication that my model would work with a dispenser. It was the best $3.95 I ever took a chance on!

I followed Gary from Sioux City IA instructions. Very well explained.

After looking at some of the other stories, I realized this was going to be a super easy fix. I moved the washer away from the wall, disconnected all the lines and then removed the pump. Seriously it took about 20 minutes start to finish, and now the washing machine sounds brand new.

I pried up the fabric sotener cover on top of the spindle with a screwdriver and removed it and softner cup holder-it twisted off. I then replaced entire softener unit which I had ordered.

I followed all the instructions from your site. It was very easy. Hardest part was the hose clamps. So it was very easy.