MAH14PSAGW Maytag Washer - Instructions

First I removed the front door. Then I removed the front of the washer. The wax motor is in the center at the top. Remove the clip that holds it in place. Slide the motor to the left and remove.
However, this was not the problem. The true problem was a plugged inlet screen where the cold water hose is connected. This makes for a long fill time during the rinse cycle, and the machine stops. Clean both of the inlet screens (cold & hot) and the machine works perfectly!

I removed the cover above the washer and below the dryer (stackable washer and dryer). Removed the spring behind the wax motor and unhooked the wires. Then I pulled out the old wax motor and put the new one in.

opened door remove door with two screws at hinge. Remove two screw opposite door hinge. Pull front cover sides near the area of the top screws you just removed. Cover will pop loose and tilt forward remove from bottom clips. Remove two screws at the top in the front of machine that is behind the front cover that was just removed. Remove four screw in soap fill door. Lift top of machine this will expose the wax motor near door latch. Remove metal clip holding wax motor in place. move motor to left and push left side of wax motor this pop the right side out of clip. You can remove two wires from wax motor. Install wax motor. Reverse order to put machine back to together.

Unplug washer.Take off front panel by removing several screws. Lift up top after removing left and right side hold down bracket. Remove wax motor(brown item on left) The rotating latch will be free to remove and replace with new items. Don't forget to reattach spring. I found that my latch was not fully engaging with the teeth slightly misaligned. The locked light was on however there are two switches. One to control the lock light and one which enables the final spin to occur. After the items were changed unit ops normally. Also fast delivery (2 day) regular shipping!

remove door with Phillips remove front panel nut driver remove soap tray lid and lift up top Phillips test small contactors for continuity and replace removed locking sprocket and replaced

When I found the WAX motor would not cycle I applied 120VAC directly to the WAX motor and machine went into SPIN CYCLE as it should have. Stopped machine and ordered replacement Machine Control Board. Replaced the part and machine works perfectly.