LSXC22486S ((ASTCNA5)) LG Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Ice chute would not open.
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
Parts Used:
-
Steve from MUKWONAGO, WI
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
13 of 29 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cold water control rusty and leaking water
Removed old part very easily and installed the new part without any problems. Used and adjustable wrench and screwdriver
Parts Used:
-
Homer from MARION, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Wrench (Adjustable)
2 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I needed a new gasket
I didn't because the part was never delivered.
The box was apparently damaged according to the tracking.
Your company didn't bother to communicate that they couldn't send another one without a new order.
They also didn't give a refund until I contacted them because they are just too busy.
Your company was a huge waste of time.
Publish that. Go ahead.
The box was apparently damaged according to the tracking.
Your company didn't bother to communicate that they couldn't send another one without a new order.
They also didn't give a refund until I contacted them because they are just too busy.
Your company was a huge waste of time.
Publish that. Go ahead.
Parts Used:
-
HEIDI from HINCKLEY, OH
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Spring was broken on original unit, had to replace whole lever.
removed old lever ( 2 screws ) took apart electrical connection, replaced lever, connected electrical hookup, put in screws. DONE !!!!!!
Parts Used:
-
Alan from Sun City West, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Change filter light came on
-
Ralph from VALLEY SPGS, CA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
2 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!